Hi,
I've recently got into SooperLooper standalone using a Lexicon MPX R1 midi foot controller > M-Audio Quattro USB (midi in and out) > MacBook.
I'm using CCs on my foot controller to trigger record, pause, etc.
The problem is : I cannot figure out how can SooperLooper send midi to my foot controller, to notice it when there's a change of state (on/off) :
For instance -only using the foot controller- I record in loop 1 with switch A. Then I record in loop 2 with switch B (loop 1 then stop recording and plays back)
Everything's ok into SooperLooper, but the LED on the switch A stays on (as if it was still recording on loop 1).
This makes things confusing after a while, and sometimes I need to switch off, then switch on again to record, kinda unpractical.
I guess I have to sync SooperLooper and my controller, so when something changes in SooperLooper, it also changes on the controller.
But how to do that ?
I've a hard time figuring this out, and will appreciate any insight/help...
Thank you very much !
Sync midi foot controller ?
Moderator: jesse