Sync midi foot controller ?

Talk about your MIDI bindings and controller setup

Moderator: jesse

Post Reply
romarola
Posts: 1
Joined: Wed Jul 15, 2009 4:39 pm

Sync midi foot controller ?

Post by romarola »

Hi,

I've recently got into SooperLooper standalone using a Lexicon MPX R1 midi foot controller > M-Audio Quattro USB (midi in and out) > MacBook.

I'm using CCs on my foot controller to trigger record, pause, etc.
The problem is : I cannot figure out how can SooperLooper send midi to my foot controller, to notice it when there's a change of state (on/off) :

For instance -only using the foot controller- I record in loop 1 with switch A. Then I record in loop 2 with switch B (loop 1 then stop recording and plays back)
Everything's ok into SooperLooper, but the LED on the switch A stays on (as if it was still recording on loop 1).
This makes things confusing after a while, and sometimes I need to switch off, then switch on again to record, kinda unpractical.

I guess I have to sync SooperLooper and my controller, so when something changes in SooperLooper, it also changes on the controller.
But how to do that ? :?:

I've a hard time figuring this out, and will appreciate any insight/help...
Thank you very much ! 8-)
Post Reply