Quantize cycle alternates loop 1 between mono and stereo

[gbevin]

Hi,

I have SooperLooper set up almost exactly as I want as an AudioUnit, sadly it seems that it triggers bug that I can't seem to work around.

I have two loops, the first one is the 'main loop' and set the record based on an audio level threshold. Once that loop is recorded, it should determine the quantize point of the second loop, so I have 'quantize' set to 'cycle' and 'sync to' to 'Loop 1'. For the second loop, I have 'sync' and 'play sync' checked and it behaves fine.

However, when I set 'quantize' to 'cycle' before recording the first loop, it alternates between a mono version of the loop (only output channel 1) and a stereo version on each playback cycle. It's only when I turn off 'quantize' when recording the first loop and switch it to 'cycle' afterwards, that everything behaves correctly.

That's a bug, right? Any chance to get it fixed soon?

Thanks,

Geert

[kasbah]

I recently experienced some strange alternating channel playback similar to what you are describing as well. Though I always have quantize set to Cycle and Cycle to Loop1 initially it seemed to have something to do with whether the track had been muted or not. I will try to track down these issues further but I can't really promise a quick fix on this.

[jesse]

This kind of thing has been a long-term and hard to track down bug for a while. By narrowing it down to certain reproducible conditions, it might be possible to track it down. It won't be an easy fix Kasbah!